'Stik-Tite' Self-Adhesive Decals
Made of Mylar, SIG's fuel proof, self-adhesive decals can be applied on all plastic covering materials (e.g. AeroKoteŽ) and painted surfaces. These decals cannot be harmed by common model airplane glow fuel containing less than 20% Nitromethane. Higher quantities of Nitromethane may cause slight deterioration of the decal over extended periods of time.
| Cut out the decal you wish to apply with sharp scissors, modeling knife or a single-edge razor blade. Trim close to the image, leaving about 1/32" (1 mm) to 1/16" (1.5 mm) of clear edge around the decal. Do not try to paint over the decals. Model cement, butyrate dope, lacquer, and some epoxy and enamel paints may dissolve the decals. If you wish to top coat your decals, be sure to test for compatibility on a scrap decal before applying the paint. Pack: 1 sheet
|